2012 Triumph Tiger 800 Specifications

Name: 2012 Triumph Tiger 800
Brand: Triumph

Enduro / Off-Road • Specs last verified 13 July 2026

No images available

Tap to enlarge

2012 Triumph Tiger 800 Overview

Triumph Tiger 800 is an enduro / off-road motorcycle, displacing 799 cc. Power comes from a Four stroke, transverse three cylinder, DOHC, 4 valve per cylinder engine, a compression ratio of 12.0:1. On the performance side, it delivers 69.1 kW @ 9300 rpm of peak power and 79 Nm @ 7850 rpm of torque. On the road, the 2012 Tiger 800 tips the scales at 209.6 kg, carries a 18.9-litre fuel tank, offers a seat height of 810 mm -830 mm and spans a 1530 mm wheelbase. That's roughly 10.8 kg heavier than the average enduro / off-road motorcycle in our database. The full 2012 Triumph Tiger 800 spec sheet below covers every technical detail, from suspension travel to tyre sizes.

2012 Tiger 800 - Pros & Cons

Strengths

Strong power output: With 69.1 kW @ 9300 rpm and 79 Nm @ 7850 rpm of torque on tap, the Tiger 800 is no slouch for its class.
Fuel injection: Fuel injection means consistent cold starts and clean throttle response without the fussiness of a carbureted setup.
Large fuel range: A 18.9-litre tank means fewer stops on longer rides - a genuine plus for touring or a lengthy daily commute.

Considerations

Chain final drive upkeep: Budget time for routine chain maintenance - it's cheap to replace but needs consistent attention to avoid premature sprocket wear.

Wear Points & Servicing Notes

Cooling system servicing

Tiger 800's Liquid cooled setup is low-maintenance provided the coolant interval is kept - old, acidic coolant is the main cause of long-term corrosion in the water passages.

Fuelling & injector care

The Multipoint sequential electronic fuel injection on the Tiger 800 needs little beyond good fuel and periodic use of an injector-cleaner additive - no jetting or float-bowl maintenance to worry about.

Brake disc and pad wear

Braking up front comes from 2 x 308 mm Floating discs, Nissin 2-piston floating caliper (ABS available), Nissin master cylinder, 14mm diameter - solid stopping power, with disc and pad wear best checked on the same schedule as tyre changes.

Suspension condition on used examples

The Tiger 800's suspension runs Showa 45mm upside down forks at the front. The rear uses Showa monoshock with remote oil reservoir, hydraulically adjustable preload, rebound damping adjustment. Fork-seal condition and rear linkage play are the two things worth checking before buying used.

Final drive maintenance

The Tiger 800 uses chain final drive, which is cheap to replace but needs regular cleaning, lubrication and tension checks to get a full service life out of the sprockets.

Frame & chassis check

Built around a Tubular steel trellis frame. Swingarm: twin-sided, cast aluminum alloy wheels, the Tiger 800's chassis is straightforward to inspect: look for corrosion, cracks or repair welds around stress points like the head-stock and swingarm mounts.

Tiger 800 - Buying & Maintenance Guide

What to check before buying

Before handing over money for a used 2012 Triumph Tiger 800, cover the fundamentals: service book and oil change history, chain and sprocket wear, and any sign of oil weeping around the casings. Cold-starting it yourself tells you a lot - a healthy Tiger 800 should catch quickly and settle into a smooth idle.

Oil and filter changes

Nothing protects a Tiger 800's engine like disciplined oil changes - stay on the manufacturer's schedule (roughly every 6,000 km or annually). Match the viscosity grade to what the owner's manual specifies, not what's cheapest.

Fuel system care

Fuel injection on the Tiger 800 needs little attention beyond decent fuel and an occasional system-cleaner additive. Anything left standing for three months or more should have its fuel drained and replaced before it varnishes the injectors.

2012 Triumph Tiger 800 - Frequently Asked Questions

What engine does the 2012 Triumph Tiger 800 have?

The 2012 Triumph Tiger 800 uses a Four stroke, transverse three cylinder, DOHC, 4 valve per cylinder engine with 799 cc of displacement. It is liquid cooled.

How much does the 2012 Triumph Tiger 800 weigh?

The 2012 Triumph Tiger 800 weighs 209.6 kg. This is the manufacturer's wet figure.

How much power does the 2012 Triumph Tiger 800 make?

The 2012 Triumph Tiger 800 produces 69.1 kW @ 9300 rpm of power and 79 Nm @ 7850 rpm of torque. These are peak figures.

What is the fuel tank capacity of the 2012 Triumph Tiger 800?

The 2012 Triumph Tiger 800 has a 18.9-litre fuel tank. At around 5-6 litres per 100 km, that is roughly 315-377 km between stops.

Is the 2012 Triumph Tiger 800 suitable for shorter riders?

The 2012 Triumph Tiger 800 has a seat height of 810 mm -830 mm. This is a moderate seat height that suits a wide range of rider heights.

What brakes does the 2012 Triumph Tiger 800 have?

The 2012 Triumph Tiger 800 uses 2 x 308 mm Floating discs, Nissin 2-piston floating caliper at the front and Single 255 mm disc, Nissin single-piston floating caliper at the rear.

What tyre sizes does the 2012 Triumph Tiger 800 use?

The 2012 Triumph Tiger 800 runs 110/80 ZR19 front and 150/70 ZR17 rear tyres. A good selection of sport, touring and all-weather rubber is available in these sizes.

What gearbox does the 2012 Triumph Tiger 800 have?

The 2012 Triumph Tiger 800 is fitted with a 6 Speed transmission.

Triumph Tiger 800 Spec Evolution

The Triumph Tiger 800 was produced across 5 model years (2011-2015). The table below highlights the key specifications that changed across the production run - useful whether you are comparing years or tracking down a specific variant.

Specification	2011	2012	2013	2014	2015
Max Power	69.1 kW / 93.9 hp @ 9300 rpm	69.1 kW / 93.9 hp @ 9300 rpm	69.1 kW / 93.9 hp @ 9300 rpm	69.1 kW / 93.9 hp @ 9300 rpm	70.8 KW / 95 hp @ 9300 rpm
Wet Weight	209.6 kg / 462 lbs	209.6 kg / 462 lbs	209.6 kg / 462 lbs	209.6 kg / 462 lbs	210 kg / 462 lbs
Engine Detail	Four stroke, transverse three cylinder, DOHC, 4 valve per cylinder	Four stroke, transverse three cylinder, DOHC, 4 valve per cylinder	Four stroke, transverse three cylinder, DOHC, 4 valve per cylinder	Four stroke, transverse three cylinder, DOHC, 4 valve per cylinder	Four stroke, transverse three cylinder, DOHC, 4 valve per cylinder.
Fuel Capacity	18.9 Litres / 5.0 gal / 4.2 Imp gal	18.9 Litres / 5.0 gal / 4.2 Imp gal	18.9 Litres / 5.0 gal / 4.2 Imp gal	18.9 Litres / 5.0 gal / 4.2 Imp gal	19 Litres / 5.0 gal / 4.3 Imp gal
Frame Type	Tubular steel trellis frame. Swingarm: twin-sided, cast aluminum alloy wheels	Tubular steel trellis frame. Swingarm: twin-sided, cast aluminum alloy wheels	Tubular steel trellis frame. Swingarm: twin-sided, cast aluminum alloy wheels	Tubular steel trellis frame. Swingarm: twin-sided, cast aluminum alloy wheels	Tubular steel trellis frame, swingarm: twin-sided, cast aluminum alloy
Displacement	799 cc / 48.7 cu-in	799 cc / 48.7 cu-in	799 cc / 48.7 cu-in	799 cc / 48.7 cu-in	799 cc / 48.7 cub in
Brakes - Front	2 x 308 mm Floating discs, Nissin 2-piston floating caliper (ABS available), Nissin master cylinder, 14mm diameter	2 x 308 mm Floating discs, Nissin 2-piston floating caliper (ABS available), Nissin master cylinder, 14mm diameter	2 x 308 mm Floating discs, Nissin 2-piston floating caliper (ABS available), Nissin master cylinder, 14mm diameter	2 x 308 mm Floating discs, Nissin 2-piston floating caliper (ABS available), Nissin master cylinder, 14mm diameter	2 x 308 mm Foating discs, Nissin 2-piston sliding caliper, ABS available
Brakes - Rear	Single 255 mm disc, Nissin single-piston floating caliper (ABS available)	Single 255 mm disc, Nissin single-piston floating caliper (ABS available)	Single 255 mm disc, Nissin single-piston floating caliper (ABS available)	Single 255 mm disc, Nissin single-piston floating caliper (ABS available)	Single 255 mm disc, Nissin single-piston sliding caliper, ABS available

Key Specifications

Engine

Four stroke, transverse three cylinder, DOHC, 4 valve per cylinder

Power

69.1 kW / 93.9 hp @ 9300 rpm

Torque

79 Nm / 8.1 kgf-m /58 ft.lb @ 7850 rpm

Top Speed

Not published by manufacturer

Weight

209.6 kg / 462 lbs

Fuel Capacity

18.9 Litres / 5.0 gal / 4.2 Imp gal

Full 2012 Triumph Tiger 800 Specifications

Year 2012

Make Model Triumph Tiger 800

Seat Height 810 mm -830 mm / 31.9 in- 32.7 in adjustable

Wheelbase 1530 mm / 60.2in

Height 1350 mm / 53.1 in

Length 2215 mm / 87.1in

Width 795 mm / 31.3 in

Fuel Capacity 18.9 Litres / 5.0 gal / 4.2 Imp gal

Wet Weight 209.6 kg / 462 lbs

Max Power 69.1 kW / 93.9 hp @ 9300 rpm

Max Torque 79 Nm / 8.1 kgf-m /58 ft.lb @ 7850 rpm

Displacement 799 cc / 48.7 cu-in

Engine Detail Four stroke, transverse three cylinder, DOHC, 4 valve per cylinder

Bore x Stroke 74 x 61.9 mm

Compression Ratio 12.0:1

Cooling System Liquid cooled

Exhaust Stainless Steel, 3 into 1, high-level stainless steel silencer

Fuel Induction Multipoint sequential electronic fuel injection

Ignition Digital CDI

Lubrication Wet sump

Starter Electric

Clutch Wet, multi-plate

Final Drive Chain

Transmission / Drive 6 Speed

Frame Type Tubular steel trellis frame. Swingarm: twin-sided, cast aluminum alloy wheels

Suspension - Front Showa 45mm upside down forks

Suspension - Rear Showa monoshock with remote oil reservoir, hydraulically adjustable preload, rebound damping adjustment

Rake 23.9°

Trail 92.4mm / 3.6 in

Wheel Travel - Front 180 mm / 7.1 in

Wheel Travel - Rear 170 mm / 6.7 in

Brakes - Front 2 x 308 mm Floating discs, Nissin 2-piston floating caliper (ABS available), Nissin master cylinder, 14mm diameter

Brakes - Rear Single 255 mm disc, Nissin single-piston floating caliper (ABS available)

Tyres - Front 110/80 ZR19

Tyres - Rear 150/70 ZR17

Specifications are compiled from manufacturer documentation and cross-referenced technical sources, and corrected on an ongoing basis. Spot an error? Let us know.