![]()
No images available
Tap to enlarge
![]()
2021 Husqvarna FC250 Overview
The 2021 Husqvarna FC250 is a cross / motocross motorcycle built around 249.9 cc of displacement. Under the tank sits a Single cylinder, four-stroke engine running Double Overhead Cams/Twin Cam (DOHC) valve actuation. The bore and stroke measures 78 x 52.3 mm. From a practical standpoint, the 2021 FC250 tips the scales at 99.5 kg, carries a 7-litre fuel tank, offers a seat height of 940 mm and spans a 1482 mm wheelbase. Scroll down for the complete 2021 Husqvarna FC250 spec sheet covering every technical detail from suspension travel to tyre sizes.
2021 FC250 - Pros & Cons
Strengths
-
✓
Factory engineering: The 2021 Husqvarna FC250 represents Husqvarna's engineering at the time, with a specification built around real-world usability.
Considerations
-
🔧
Carburetor fuelling: Carbureted engines need occasional jetting attention and can be reluctant in cold weather or at altitude compared to modern fuel-injected alternatives.
-
📏
Tall seat height: The 940 mm seat height will challenge shorter riders - tiptoeing at low speeds is something to factor into your decision.
Owner Experiences & Common Issues
Carburetor maintenance
Carburetors on the 2021 Husqvarna FC250 benefit from a clean and re-jet if the bike has been stored, run on stale fuel, or modified with an aftermarket exhaust. Owners frequently mention that fresh jets and float needle clips transforms throttle response from flat to crisp.
Valve clearance checks
Double Overhead Cams/Twin Cam (DOHC) engines should have valve clearances checked at the manufacturer's specified interval. Owners report that clearances can tighten over time on higher-mileage bikes, leading to slight ticking from the top end. Catching it early keeps the job simple and avoids more costly remediation.
FC250 - Buying & Maintenance Guide
What to check before buying
When inspecting a used 2021 Husqvarna FC250, start with the basics: check the service book for oil change frequency, inspect the chain and sprockets for wear, and look for oil seepage around the engine casings and rocker covers. A cold start test is invaluable - a well-maintained FC250 should fire up cleanly and settle to a smooth idle within a few seconds.
Oil and filter changes
Regular oil changes are the single most important maintenance task on any FC250. Stick to the manufacturer's interval - typically every 6,000 km or once a year, whichever comes first. Always use the correct viscosity grade as specified in the owner's manual.
Carburetor upkeep
Keep the carburetors clean and free of deposits. If the FC250 has been stored, strip and clean the carb float bowls before attempting to start it. Pilot jets are the first to block and the last to be checked - always include them in any carb rebuild.
Valve clearance service
Check that valve clearances have been adjusted at the correct intervals on any used FC250. This is a job many owners skip because the bike does not immediately feel wrong - but tight clearances accelerate valve seat wear. Ask for proof it has been done.
2021 Husqvarna FC250 - Frequently Asked Questions
What engine does the 2021 Husqvarna FC250 have?
The 2021 Husqvarna FC250 uses a Single cylinder, four-stroke engine with 249.9 cc of displacement.
How much does the 2021 Husqvarna FC250 weigh?
The 2021 Husqvarna FC250 weighs 99.5 kg. This is the manufacturer's dry figure.
What is the fuel tank capacity of the 2021 Husqvarna FC250?
The 2021 Husqvarna FC250 has a 7-litre fuel tank.
Is the 2021 Husqvarna FC250 suitable for shorter riders?
The 2021 Husqvarna FC250 has a seat height of 940 mm. This is towards the tall end of the spectrum and will require most riders under 175 cm to tiptoe at stops.
What brakes does the 2021 Husqvarna FC250 have?
The 2021 Husqvarna FC250 uses Single disc. Brembo twin-piston floating calliper at the front and Single disc. Brembo single-piston floating calliper at the rear.
What tyre sizes does the 2021 Husqvarna FC250 use?
The front tyre size on the 2021 Husqvarna FC250 is 90/90-21.
What fuel system does the 2021 Husqvarna FC250 use?
The 2021 Husqvarna FC250 uses Carburettor, providing precise fuelling across the rev range and reliable cold-start behaviour.
Husqvarna FC250 Spec Evolution
The Husqvarna FC250 was produced across 9 model years (2014-2023). The table below highlights the key specifications that changed across the production run - useful whether you are comparing years or tracking down a specific variant.
| Specification |
2014 |
2016 |
2017 |
2018 |
2019 |
2020 |
2021 |
2022 |
2023 |
| Dry Weight |
104.1 kg / 229.5 lbs |
101.1 kg / 222.9 lbs |
98.8 kg / 217.8 lbs |
98.8 kg / 217.8 lbs |
99.5 kg / 219.4 lbs |
99.5 kg / 219.4 lbs |
99.5 kg / 219.4 lbs |
99.5 kg / 219.4 lbs |
101.5 kg / 223.8 lbs |
| Engine Detail |
Reed intake. |
- |
- |
- |
- |
- |
- |
- |
Titanium valves |
| Seat Height |
992 mm / 39.1 in. |
960 mm / 37.8 in. |
960 mm / 37.8 in. |
960 mm / 37.8 in. |
950 mm / 37.4 in. |
950 mm / 37.4 in. |
940 mm / 37.0 in. |
940 mm / 37.0 in. |
939 mm / 37.0 in. |
| Fuel Capacity |
7.50 litres / 1.98 gallons |
7.00 litres / 1.85 gallons |
7.00 litres / 1.85 gallons |
7.00 litres / 1.85 gallons |
7.00 litres / 1.85 US gallons |
7.00 litres / 1.85 US gallons |
7.00 litres / 1.85 US gallons |
7.00 litres / 1.85 US gallons |
7.20 litres / 1.90 US gallons |
| Ground Clearance (mm) |
375 mm |
370 mm |
370 mm |
370 mm |
370 mm |
370 mm |
370 mm |
370 mm |
336 mm |
| Ground Clearance (in.) |
14.8 inches |
14.6 inches |
14.6 inches |
14.6 inches |
14.6 inches |
14.6 inches |
14.6 inches |
14.6 inches |
13.2 inches |
| Fuel Control |
DOHC |
Double Overhead Cams/Twin Cam (DOHC) |
Double Overhead Cams/Twin Cam (DOHC) |
Double Overhead Cams/Twin Cam (DOHC) |
Double Overhead Cams/Twin Cam (DOHC) |
Double Overhead Cams/Twin Cam (DOHC) |
Double Overhead Cams/Twin Cam (DOHC) |
Double Overhead Cams/Twin Cam (DOHC) |
Double Overhead Cams/Twin Cam (DOHC) |
| Displacement (cc) |
249.91 cc |
249.91 cc |
249.91 cc |
249.91 cc |
249.9 cc |
249.9 cc |
249.9 cc |
249.9 cc |
249.9 cc |
Key Specifications
Engine
Single cylinder, four-stroke
Weight
99.5 kg / 219.4 lbs
Fuel Capacity
7.00 litres / 1.85 US gallons
Advertisement
Full 2021 Husqvarna FC250 Specifications
Colours
White/yellow/blue
Ground Clearance (in.)
14.6 inches
Ground Clearance (mm)
370 mm
Seat Height
940 mm / 37.0 in.
Wheelbase
1482 mm / 58.3 in.
Length
2260 mm / 89.0 in.
Dry Weight
99.5 kg / 219.4 lbs
Fuel Capacity
7.00 litres / 1.85 US gallons
Bore x Stroke (in,)
3.1 x 2.1 inches
Bore x Stroke (mm)
78.0 x 52.3 mm
Displacement (cc)
249.9 cc
Displacement (ci)
15.25 cubic inches
Engine Type
Single cylinder, four-stroke
Fuel Control
Double Overhead Cams/Twin Cam (DOHC)
Fuel System
Carburettor
Ignition
Keihin EMS
Starter
Electric
Clutch
Wet, multi-disc clutch, Magura hydraulics
Final Drive
Chain (final drive)
Gearbox
5-speed
Frame Type
Central double-cradle-type 25CrMo4 steel
Suspension - Front
WP XACT-USD, Ø 48 mm
Suspension - Rear
WP XACT Monoshock with linkage
Rake
26.1°
Wheel Travel - Front
300 mm / 11.8 in.
Wheel Travel - Rear
300 mm / 11.8 in.
Brakes - Front
Single disc. Brembo twin-piston floating calliper
Brakes - Rear
Single disc. Brembo single-piston floating calliper
Tyres - Front
90/90-21
Advertisement