![]()
No images available
Tap to enlarge
![]()
2019 Husqvarna TE 300 Overview
The 2019 Husqvarna TE 300 is an enduro / off-road motorcycle built around 293.2 cc of displacement. Under the tank sits a Single cylinder, two-stroke engine running Double Overhead Cams/Twin Cam (DOHC) valve actuation, a compression ratio of NA. 2019 Husqvarna TE 300 delivers NA of peak power. From a practical standpoint, the 2019 TE 300 tips the scales at 102.4 kg, carries a 10-litre fuel tank, offers a seat height of 960 mm and spans a 1482±10 mm wheelbase. Scroll down for the complete 2019 Husqvarna TE 300 spec sheet covering every technical detail from suspension travel to tyre sizes.
2019 TE 300 - Pros & Cons
Strengths
-
⚡
Capable power output: At NA, the TE 300 holds its own against class rivals.
Considerations
-
🔧
Carburetor fuelling: Carbureted engines need occasional jetting attention and can be reluctant in cold weather or at altitude compared to modern fuel-injected alternatives.
-
📏
Tall seat height: The 960 mm seat height will challenge shorter riders - tiptoeing at low speeds is something to factor into your decision.
-
⛽
Modest fuel capacity: The 10-litre tank means more frequent fuel stops on longer rides, which is worth planning around on touring routes.
Owner Experiences & Common Issues
Carburetor maintenance
Carburetors on the 2019 Husqvarna TE 300 benefit from a clean and re-jet if the bike has been stored, run on stale fuel, or modified with an aftermarket exhaust. Owners frequently mention that fresh jets and float needle clips transforms throttle response from flat to crisp.
Valve clearance checks
Double Overhead Cams/Twin Cam (DOHC) engines should have valve clearances checked at the manufacturer's specified interval. Owners report that clearances can tighten over time on higher-mileage bikes, leading to slight ticking from the top end. Catching it early keeps the job simple and avoids more costly remediation.
TE 300 - Buying & Maintenance Guide
What to check before buying
When inspecting a used 2019 Husqvarna TE 300, start with the basics: check the service book for oil change frequency, inspect the chain and sprockets for wear, and look for oil seepage around the engine casings and rocker covers. A cold start test is invaluable - a well-maintained TE 300 should fire up cleanly and settle to a smooth idle within a few seconds.
Oil and filter changes
Regular oil changes are the single most important maintenance task on any TE 300. Stick to the manufacturer's interval - typically every 6,000 km or once a year, whichever comes first. Always use the correct viscosity grade as specified in the owner's manual.
Carburetor upkeep
Keep the carburetors clean and free of deposits. If the TE 300 has been stored, strip and clean the carb float bowls before attempting to start it. Pilot jets are the first to block and the last to be checked - always include them in any carb rebuild.
Valve clearance service
Check that valve clearances have been adjusted at the correct intervals on any used TE 300. This is a job many owners skip because the bike does not immediately feel wrong - but tight clearances accelerate valve seat wear. Ask for proof it has been done.
2019 Husqvarna TE 300 - Frequently Asked Questions
What engine does the 2019 Husqvarna TE 300 have?
The 2019 Husqvarna TE 300 uses a Single cylinder, two-stroke engine with 293.2 cc of displacement. It is liquid cooled.
How much does the 2019 Husqvarna TE 300 weigh?
The 2019 Husqvarna TE 300 weighs 102.4 kg. This is the manufacturer's dry figure.
How much power does the 2019 Husqvarna TE 300 make?
The 2019 Husqvarna TE 300 produces NA of power.
What is the fuel tank capacity of the 2019 Husqvarna TE 300?
The 2019 Husqvarna TE 300 has a 10-litre fuel tank. At around 5-6 litres per 100 km, that is roughly 166-200 km between stops.
Is the 2019 Husqvarna TE 300 suitable for shorter riders?
The 2019 Husqvarna TE 300 has a seat height of 960 mm. This is towards the tall end of the spectrum and will require most riders under 175 cm to tiptoe at stops.
What brakes does the 2019 Husqvarna TE 300 have?
The 2019 Husqvarna TE 300 uses Single 260mm disc at the front and Single 220mm disc at the rear.
What tyre sizes does the 2019 Husqvarna TE 300 use?
The 2019 Husqvarna TE 300 runs 90/90-21 front and 140/90-18 rear tyres. A good selection of sport, touring and all-weather rubber is available in these sizes.
What gearbox does the 2019 Husqvarna TE 300 have?
The 2019 Husqvarna TE 300 is fitted with a 6 Speed transmission.
Husqvarna TE 300 Spec Evolution
The Husqvarna TE 300 was produced across 4 model years (2015-2023). The table below highlights the key specifications that changed across the production run - useful whether you are comparing years or tracking down a specific variant.
| Specification |
2015 |
2017 |
2019 |
2023 |
| Dry Weight |
102.4 kg / 225.8 lbs |
102.4 kg / 225.8 lbs |
102.4 kg / 225.8 lbs |
106.4 kg / 234.6 lbs |
| Engine Detail |
Two stroke, single cylinder with reed intake and exhaust control |
Two stroke, single cylinder with reed intake and exhaust control |
Two stroke, single cylinder with reed intake and exhaust control |
- |
| Seat Height |
960 mm / 38.0 in |
960 mm / 38.0 in |
960 mm / 38.0 in |
950 mm / 37.4 in. |
| Fuel Capacity |
10 Litres / 2.6 US gal |
10 Litres / 2.6 US gal |
10 Litres / 2.6 US gal |
9.00 litres / 2.38 US gallons |
| Ground Clearance (mm) |
355 mm |
355 mm |
370 mm |
375 mm |
| Ground Clearance (in.) |
14.0 inches |
14.0 inches |
14.6 inches |
14.8 inches |
| Fuel Control |
DOHC |
Double Overhead Cams/Twin Cam (DOHC) |
Double Overhead Cams/Twin Cam (DOHC) |
Double Overhead Cams/Twin Cam (DOHC) |
| Brakes - Front Diameter (in.) |
10.2 inches |
10.2 inches |
10.2 inches |
- |
Key Specifications
Engine
Single cylinder, two-stroke
Weight
102.4 kg / 225.8 lbs
Fuel Capacity
10 Litres / 2.6 US gal
Advertisement
Full 2019 Husqvarna TE 300 Specifications
Year
2018 - 19
Colours
White/blue/yellow
Make Model
Husqvarna TE 300
Ground Clearance (mm)
370 mm
Ground Clearance (in.)
14.6 inches
Seat Height
960 mm / 38.0 in
Wheelbase
1482±10 mm / 58.3 in
Ground Clearance
355 mm / 14.0 in
Length
2260 mm / 89.0 in
Dry Weight
102.4 kg / 225.8 lbs
Fuel Capacity
10 Litres / 2.6 US gal
Fuel Control
Double Overhead Cams/Twin Cam (DOHC)
Engine Type
Single cylinder, two-stroke
Displacement
293.2 cc / 17.8 cu-in
Engine Detail
Two stroke, single cylinder with reed intake and exhaust control
Fuel System
Carburettor. 38mm flat slide Mikuni TMX
Bore x Stroke
72 x 72 mm
Compression Ratio
NA
Cooling System
Liquid cooled
Engine Lubrication
Mixture oil lubrication
Fuel Induction
DellØ Orto EFI with 39mm throttle body
Ignition
Contactless, controlled, fully electronic ignition system with digital ignition timing adjustment, type Kokusan
Lubrication
Mixture oil lubrication
Starter
Electric & kick
Clutch
Wet, DDS multi-disc clutch, Brembo hydraulics
Final Drive
Chain 520 X-Ring
Gearbox
6-speed
Primary Drive
Constant mesh
Primary Drive Ratios
26:72
Secondary Drive Ratio
14:50 (13:50)
Transmission / Drive
6 Speed
Frame Type
Central tube frame made of chrome molybdenum steel tubing
Suspension - Front
WP Suspension Up Side Down 4CS
Suspension - Rear
WP Monoshock with linkage
Rake
26.5°
Trail
107 mm / 4.2 in
Wheel Travel - Front
300 mm / 11.8 in
Wheel Travel - Rear
330 mm / 13.0 in
Brakes - Front Diameter (in.)
10.2 inches
Brakes - Front Diameter (mm)
260 mm
Brakes - Rear Diameter (in.)
8.7 inches
Brakes - Rear Diameter (mm)
220 mm
Brakes - Front
Single 260mm disc
Brakes - Rear
Single 220mm disc
Tyres - Front
90/90-21
Tyres - Rear
140/90-18
Advertisement