![]()
No images available
Tap to enlarge
![]()
2020 Husqvarna FE 501 Overview
The 2020 Husqvarna FE 501 is an enduro / off-road motorcycle built around 510.4 cc of displacement. Under the tank sits a Single cylinder, four-stroke engine running Single Overhead Cams (SOHC) valve actuation, a compression ratio of 12.7:1.. 2020 Husqvarna FE 501 delivers 45 hp of peak power and Nm @ rpm of torque. From a practical standpoint, the 2020 FE 501 tips the scales at 111 kg, carries a 8.5-litre fuel tank, offers a seat height of 970 mm and spans a 1482±10 mm wheelbase. Scroll down for the complete 2020 Husqvarna FE 501 spec sheet covering every technical detail from suspension travel to tyre sizes.
2020 FE 501 - Pros & Cons
Strengths
-
⚡
Strong power output: 2020 Husqvarna FE 501 makes 45 hp with Nm @ rpm of torque - competitive figures for its class.
Considerations
-
🔧
Carburetor fuelling: Carbureted engines need occasional jetting attention and can be reluctant in cold weather or at altitude compared to modern fuel-injected alternatives.
-
📏
Tall seat height: The 970 mm seat height will challenge shorter riders - tiptoeing at low speeds is something to factor into your decision.
Owner Experiences & Common Issues
Carburetor maintenance
Carburetors on the 2020 Husqvarna FE 501 benefit from a clean and re-jet if the bike has been stored, run on stale fuel, or modified with an aftermarket exhaust. Owners frequently mention that fresh jets and float needle clips transforms throttle response from flat to crisp.
Valve clearance checks
Single Overhead Cams (SOHC) engines should have valve clearances checked at the manufacturer's specified interval. Owners report that clearances can tighten over time on higher-mileage bikes, leading to slight ticking from the top end. Catching it early keeps the job simple and avoids more costly remediation.
FE 501 - Buying & Maintenance Guide
What to check before buying
When inspecting a used 2020 Husqvarna FE 501, start with the basics: check the service book for oil change frequency, inspect the chain and sprockets for wear, and look for oil seepage around the engine casings and rocker covers. A cold start test is invaluable - a well-maintained FE 501 should fire up cleanly and settle to a smooth idle within a few seconds.
Oil and filter changes
Regular oil changes are the single most important maintenance task on any FE 501. Stick to the manufacturer's interval - typically every 6,000 km or once a year, whichever comes first. Always use the correct viscosity grade as specified in the owner's manual.
Carburetor upkeep
Keep the carburetors clean and free of deposits. If the FE 501 has been stored, strip and clean the carb float bowls before attempting to start it. Pilot jets are the first to block and the last to be checked - always include them in any carb rebuild.
Valve clearance service
Check that valve clearances have been adjusted at the correct intervals on any used FE 501. This is a job many owners skip because the bike does not immediately feel wrong - but tight clearances accelerate valve seat wear. Ask for proof it has been done.
2020 Husqvarna FE 501 - Frequently Asked Questions
What engine does the 2020 Husqvarna FE 501 have?
The 2020 Husqvarna FE 501 uses a Single cylinder, four-stroke engine with 510.4 cc of displacement. It is liquid cooling system, continuous circulation of cooling liquid with water pump.
How much does the 2020 Husqvarna FE 501 weigh?
The 2020 Husqvarna FE 501 weighs 111 kg. This is the manufacturer's dry figure.
How much power does the 2020 Husqvarna FE 501 make?
The 2020 Husqvarna FE 501 produces 45 hp of power and Nm @ rpm of torque. These are peak figures.
What is the fuel tank capacity of the 2020 Husqvarna FE 501?
The 2020 Husqvarna FE 501 has a 8.5-litre fuel tank.
Is the 2020 Husqvarna FE 501 suitable for shorter riders?
The 2020 Husqvarna FE 501 has a seat height of 970 mm. This is towards the tall end of the spectrum and will require most riders under 175 cm to tiptoe at stops.
What brakes does the 2020 Husqvarna FE 501 have?
The 2020 Husqvarna FE 501 uses Single 260 mm with 4 pot brake caliper at the front and Single 220 mm with 1 pot brake caliper at the rear.
What tyre sizes does the 2020 Husqvarna FE 501 use?
The 2020 Husqvarna FE 501 runs 90/90-21 front and 140/80-18 rear tyres. A good selection of sport, touring and all-weather rubber is available in these sizes.
What gearbox does the 2020 Husqvarna FE 501 have?
The 2020 Husqvarna FE 501 is fitted with a 6 Speed, claw shifted transmission.
Husqvarna FE 501 Spec Evolution
The Husqvarna FE 501 was produced across 8 model years (2015-2023). The table below highlights the key specifications that changed across the production run - useful whether you are comparing years or tracking down a specific variant.
| Specification |
2015 |
2016 |
2017 |
2018 |
2019 |
2021 |
2022 |
2023 |
| Dry Weight |
113.5 kg / 250.2 lbs |
111 kg / 244.7 lbs |
111 kg / 244.7 lbs |
111 kg / 244.7 lbs |
111 kg / 244.7 lbs |
111 kg / 244.7 lbs |
111 kg / 244.7 lbs |
108.4 kg / 239.0 lbs |
| Engine Detail |
Four stroke. single cylinder. SOHC. 4 valve per cylinder |
- |
- |
- |
- |
Four stroke. single cylinder. SOHC. 4 valve per cylinder |
Four stroke. single cylinder. SOHC. 4 valve per cylinder |
Titanium valves |
| Seat Height |
970 mm / 38.2 in |
970 mm / 38.2 in. |
970 mm / 38.2 in. |
970 mm / 38.2 in. |
970 mm / 38.2 in. |
970 mm / 38.2 in |
970 mm / 38.2 in |
950 mm / 37.4 in. |
| Fuel Capacity |
9.5 Litres / 2.8 US gal |
9.00 litres / 2.38 gallons |
8.50 litres / 2.25 gallons |
8.50 litres / 2.25 gallons |
8.50 litres / 2.25 US gallons |
8.50 litres / 2.25 US gallons |
8.5 Litres / 2.25 US gal |
9.00 litres / 2.38 US gallons |
| Ground Clearance (mm) |
345 mm |
345 mm |
370 mm |
370 mm |
370 mm |
360 mm |
360 mm |
360 mm |
| Ground Clearance (in.) |
13.6 inches |
13.6 inches |
14.6 inches |
14.6 inches |
14.6 inches |
14.2 inches |
14.2 inches |
14.2 inches |
| Fuel Control |
SOHC |
Single Overhead Cams (SOHC) |
Single Overhead Cams (SOHC) |
Single Overhead Cams (SOHC) |
Single Overhead Cams (SOHC) |
Single Overhead Cams (SOHC) |
Single Overhead Cams (SOHC) |
Single Overhead Cams (SOHC) |
| Displacement (ci) |
- |
31.14 cubic inches |
31.14 cubic inches |
31.14 cubic inches |
31.18 cubic inches |
31.14 cubic inches |
- |
31.18 cubic inches |
Key Specifications
Engine
Single cylinder, four-stroke
Weight
111 kg / 244.7 lbs
Fuel Capacity
8.5 Litres / 2.25 US gal
Advertisement
Full 2020 Husqvarna FE 501 Specifications
Year
2020 - 21
Colours
White/blue/yellow
Make Model
Husqvarna FE 501
Ground Clearance (mm)
360 mm
Ground Clearance (in.)
14.2 inches
Seat Height
970 mm / 38.2 in
Wheelbase
1482±10 mm / 58.3 in
Ground Clearance
370 mm / 14.6 in
Length
2260 mm / 89.0 in
Dry Weight
111 kg / 244.7 lbs
Fuel Capacity
8.5 Litres / 2.25 US gal
Fuel Control
Single Overhead Cams (SOHC)
Engine Type
Single cylinder, four-stroke
Displacement
510.4 cc / 31.1 cu in
Engine Detail
Four stroke. single cylinder. SOHC. 4 valve per cylinder
Fuel System
Carburettor
Bore x Stroke
95 x 72.0 mm
Compression Ratio
12.7:1.
Cooling System
Liquid cooling system, continuous circulation of cooling liquid with water pump
Fuel Induction
Keihin electronic fuel injection and 42mm throttle body
Ignition
Keihin EMS
Lubrication
Forced oil lubrication with 2 Eaton pumps
Starter
Electric
Clutch
Wet, DDS multi-disc clutch, Magura hydraulics
Final Drive
Chain 520 X-Ring
Gearbox
6-speed
Primary Drive
X-ring 5/8 x 1/4 in chain
Primary Drive Ratios
31:76
Secondary Drive Ratio
14:52 (13:52)
Transmission / Drive
6 Speed, claw shifted
Frame Type
Frame design 25CrMo4 steel central-tube
Suspension - Front
WP-USD Xplor 48 with preload adjuster
Suspension - Rear
WP shock absorber with linkage
Rake
26.5
Steering Head Angle
63.5°
Trail
107 mm / 4.2 in
Wheel Travel - Front
300 mm /11.8 in
Wheel Travel - Rear
300 mm / 11.8 in
Brakes - Front
Single 260 mm with 4 pot brake caliper
Brakes - Rear
Single 220 mm with 1 pot brake caliper
Tyres - Front
90/90-21
Tyres - Rear
140/80-18
Advertisement