No images available
Tap to enlarge
2020 Honda CRF 250L Overview
For 2020, Honda offers the CRF 250L as an enduro / off-road motorcycle with 249.6 cc on tap. The 2020 Honda CRF 250L is built around a Single cylinder, four-stroke engine running Double Overhead Cams/Twin Cam (DOHC) valve actuation, a compression ratio of 10.7:1. Internally, bore and stroke are 76 x 55 mm. Out on the road, the CRF 250L delivers 22 Nm @ 7000 Revolutions of torque. In everyday use, the 2020 CRF 250L tips the scales at 146 kg, carries a 7.95-litre fuel tank, offers a seat height of 874 mm and spans a 1445 mm wheelbase. That's roughly 23.5 kg lighter than the average enduro / off-road motorcycle in our database. Every technical detail, from suspension travel to tyre sizes, is covered in the full 2020 Honda CRF 250L spec sheet below.
2020 Honda CRF 250L compared with other bikes in the Enduro / Off-Road category
Measured against other bikes in the Enduro / Off-Road category in our database (up to 1434 models, one entry per model), the 2020 Honda CRF 250L comes out as follows.
- With 22 Nm, the CRF 250L has the joint 183rd lowest torque of 816 bikes in the Enduro / Off-Road category, 63% below the category average of 58.9 Nm.
- Engine displacement of 250 cc is smaller than that of 924 of the other 1433 bikes in the Enduro / Off-Road category.
- Narrowing the field to the 291 models within five model years of it, the torque of 22 Nm is lower than that of 255 of the other 290.
Versus the 2019 model
Compared with the 2019 model, wet weight went up from 144 kg to 146 kg (+2 kg). Peak torque, displacement and seat height are unchanged.
2020 CRF 250L - Pros & Cons
Strengths
-
🔧
Fuel injection: No choke, no jetting, no altitude compensation to think about - fuel injection just works across a wider range of conditions than carburetion.
-
🛑
Strong front braking: The single disc front brake bites hard and stays consistent - a solid foundation whether it's stock or upgraded with braided lines.
Considerations
-
📏
Tall seat height: An 874 mm seat puts flat-footing out of reach for a lot of riders - sit on it in person before committing.
-
⛽
Modest fuel capacity: A 7.95-litre tank keeps things light but means budgeting for more frequent fuel stops on any longer ride.
-
⚙️
Chain final drive upkeep: A chain drivetrain is the most common setup in its class, but it's also the one that demands the most regular hands-on maintenance.
Wear Points & Servicing Notes
Fuelling & injector care
Fuelling on the CRF 250L comes from fuel injection. Cold starts and throttle response stay consistent across altitude and temperature, the main practical edge over a carbureted equivalent.
Valve clearance checks
Valve clearances on Double Overhead Cams/Twin Cam (DOHC)-equipped engines like the CRF 250L's drift slowly with mileage rather than failing suddenly - sticking to the service interval keeps it a non-issue.
Brake disc and pad wear
Single disc with two-piston calipers up front provides the primary stopping power; inspect disc thickness and pad wear at each tyre change to catch scoring before it becomes a rotor replacement.
Suspension condition on used examples
Suspension duties are handled by 43mm inverted fork up front and Pro-Link® single shock with spring; at the rear. Weeping fork seals aren't a dealbreaker on a used bike, but they're a fair basis for negotiating price.
Final drive maintenance
Chain final drive on the CRF 250L means routine lubing and tension checks are part of ownership - skip them and sprocket wear accelerates noticeably.
CRF 250L - Buying & Maintenance Guide
What to check before buying
A pre-purchase check on the 2020 Honda CRF 250L with its 249.6 cc enduro / off-road should cover the same ground every time: service history, drivetrain condition, and any oil seepage around the casings. This model runs chain final drive, so check chain slack and sprocket tooth profile specifically - a worn sprocket is a cheaper fix now than after it's chewed up the next chain. Now 6 years old, this enduro / off-road is as likely to show age-related wear (perished rubber, seized fasteners, degraded seals) as mileage-related wear. Start it from cold if you can - a well-kept CRF 250L settles to a smooth idle within seconds.
Oil and filter changes
Oil changes are the cheapest insurance you can buy for the CRF 250L's 249.6 cc single cylinder, four-stroke - keep to the manufacturer's interval rather than stretching it. The sump holds 1.80 litres, so budget for that volume of quality motorcycle-specific engine oil. With a 10.7:1 compression ratio, running the octane grade specified in the manual matters more than on a lower-compression engine. Use the viscosity grade the manual specifies, not whatever's on sale.
Fuel system care
Injector systems like the CRF 250L's hold up well with basic care - decent fuel, an occasional cleaner additive, and draining old fuel before any layup longer than three months.
Valve clearance service
There's no reliable seat-of-the-pants way to tell if a CRF 250L's valve clearances are in spec - a light top-end tick is the only real warning sign, and by then some wear has already happened. Service records are the only proof.
2020 Honda CRF 250L - Frequently Asked Questions
What engine does the 2020 Honda CRF 250L have?
The 2020 Honda CRF 250L uses a Single cylinder, four-stroke engine with 249.6 cc of displacement.
How much does the 2020 Honda CRF 250L weigh?
The 2020 Honda CRF 250L weighs 146 kg. This is the manufacturer's wet figure.
How much torque does the 2020 Honda CRF 250L produce?
The 2020 Honda CRF 250L produces 22 Nm @ 7000 Revolutions of torque.
What is the fuel tank capacity of the 2020 Honda CRF 250L?
The 2020 Honda CRF 250L has a 7.95-litre fuel tank. At around 5-6 litres per 100 km, that is roughly 132-159 km between stops.
Is the 2020 Honda CRF 250L suitable for shorter riders?
The 2020 Honda CRF 250L has a seat height of 874 mm. This is towards the tall end of the spectrum and will require most riders under 175 cm to tiptoe at stops.
What brakes does the 2020 Honda CRF 250L have?
The 2020 Honda CRF 250L uses single disc with two-piston calipers at the front and single disc at the rear.
What tyre sizes does the 2020 Honda CRF 250L use?
The front tyre size on the 2020 Honda CRF 250L is 3.00-21.
How much oil does the 2020 Honda CRF 250L take?
The 2020 Honda CRF 250L takes 1.80 litres of engine oil at a full oil and filter change. Always verify against the dipstick or sight glass after filling.
Honda CRF 250L Spec Evolution
The Honda CRF 250L was produced across 7 model years (2013-2020). The table below highlights the key specifications that changed across the production run - useful whether you are comparing years or tracking down a specific variant.
| Specification |
2013 |
2015 |
2016 |
2017 |
2018 |
2019 |
2020 |
| Wet Weight |
147 kg / 320 lbs |
145.2 kg / 320.0 lbs |
147 kg / 320 lbs |
145.2 kg / 320.0 lbs |
145.2 kg / 320.0 lbs |
144.0 kg / 317.5 lbs |
146.0 kg / 321.9 lbs |
| Seat Height |
875 mm / 34.4 in. |
875 mm / 34.7 in |
875 mm / 34.7 in |
881 mm / 34.7 in. |
881 mm / 34.7 in. |
874 mm / 34.4 in. |
874 mm / 34.4 in. |
| Fuel Capacity |
7.7 Litres / 2.0 US gal |
7.7 Litres / 2.0 gal |
7.7 Litres / 2.0 gal |
7.57 litres / 2.00 gallons |
7.57 litres / 2.00 gallons |
7.95 litres / 2.10 US gallons |
7.95 litres / 2.10 US gallons |
| Oil Capacity (Quarts) |
0.12 quarts |
0.12 quarts |
0.12 quarts |
0.12 quarts |
0.12 quarts |
1.9 US quarts |
1.9 US quarts |
| Ground Clearance (mm) |
255 mm |
254 mm |
254 mm |
254 mm |
254 mm |
254 mm |
254 mm |
| Fuel Control |
DOHC |
DOHC |
Double Overhead Cams/Twin Cam (DOHC) |
Double Overhead Cams/Twin Cam (DOHC) |
Double Overhead Cams/Twin Cam (DOHC) |
Double Overhead Cams/Twin Cam (DOHC) |
Double Overhead Cams/Twin Cam (DOHC) |
| Displacement (ci) |
15.26 cubic inches |
- |
- |
- |
- |
15.23 cubic inches |
15.23 cubic inches |
| Displacement (cc) |
250.00 cc |
- |
- |
- |
- |
249.6 cc |
249.6 cc |
Key Specifications
Engine
Single cylinder, four-stroke
Torque
22.0 Nm (2.2 kgf-m or 16.2 ft.lbs) @ 7000 Revolutions
Weight
146.0 kg / 321.9 lbs
Fuel Capacity
7.95 litres / 2.10 US gallons
Advertisement
Full 2020 Honda CRF 250L Specifications
Comments
Model ID: CRF250L.
Colours
Red
Warranty
One year. Unlimited milage. Transferable.
Ground Clearance (in.)
10.0 inches
Ground Clearance (mm)
254 mm
Seat Height
874 mm / 34.4 in.
Wheelbase
1445 mm / 56.9 in.
Height
1195 mm / 47.0 in.
Length
2195 mm / 86.4 in.
Width
815 mm / 32.1 in.
Oil Capacity (l)
1.80 litres
Oil Capacity (Quarts)
1.9 US quarts
Fuel Capacity
7.95 litres / 2.10 US gallons
Wet Weight
146.0 kg / 321.9 lbs
Displacement (cc)
249.6 cc
Displacement (ci)
15.23 cubic inches
Engine Type
Single cylinder, four-stroke
Fuel Control
Double Overhead Cams/Twin Cam (DOHC)
Bore x Stroke (in,)
3.0 x 2.2 inches
Bore x Stroke (mm)
76.0 x 55.0 mm
CO2
74.7 CO2 g/km. (CO2 - Carbon dioxide emission)
Fuel System
Injection. PGM-FI, 38mm throttle body
Compression Ratio
10.7:1
Fuel Consumption
3.22 litres/100 km (31.1 km/l or 73.05 mpg)
Ignition
Computer-controlled digital transistorized with electronic advance
Starter
Electric
Valve System
4
Clutch
Wet multiplate with coil springs
Final Drive
Chain (final drive)
Gearbox
6-speed
Primary Drive
#520 chain; 14T/40T
Suspension - Front
43mm inverted fork
Suspension - Rear
Pro-Link® single shock with spring;
Rake
27.6°
Trail
113 mm / 4.4 in.
Wheel Travel - Front
249 mm / 9.8 in.
Wheel Travel - Rear
239 mm / 9.4 in.
Brakes - Front
Single disc. Two-piston calipers.
Brakes - Rear
Single disc
Tyres - Front
3.00-21
Specifications are compiled from manufacturer documentation and cross-referenced
technical sources, and corrected on an ongoing basis.
Spot an error? Let us know.
Advertisement