2008 Yamaha WR 250F Specifications

Enduro / Off-Road • Specs last verified 13 July 2026

No images available
Tap to enlarge

2008 Yamaha WR 250F Overview

The 2008 Yamaha WR 250F is an enduro / off-road motorcycle built around 249 cc of displacement. Under the tank sits a Single cylinder engine running DOHC valve actuation, a compression ratio of 12.5:1. The bore and stroke measures 77 x 53.6 mm. From a practical standpoint, the 2008 WR 250F tips the scales at 129 kg, carries an 8-litre fuel tank, offers a seat height of 980 mm and spans a 1475 mm wheelbase. That's roughly 40.3 kg lighter than the average enduro / off-road motorcycle in our database. Scroll down for the complete 2008 Yamaha WR 250F spec sheet covering every technical detail from suspension travel to tyre sizes.

2008 Yamaha WR 250F compared with other bikes in the Enduro / Off-Road category

Here is how the 2008 Yamaha WR 250F stacks up against other bikes in the Enduro / Off-Road category in our database. Each model counts once, using the model year closest to this one, and the comparison covers up to 1146 models.

  • Seat height of 980 mm is taller than that of 1107 of the other 1145 bikes in the Enduro / Off-Road category.
  • Only 245 of the other 773 bikes in the Enduro / Off-Road category have a lighter wet weight than the 129 kg of the WR 250F.
  • Narrowing the field to the 484 models within five model years of it, the seat height of 980 mm is taller than that of 449 of the other 483.

Versus the 2006 model

Compared with the 2006 model, displacement grew from 249 cc to 250 cc (+1 cc) and seat height dropped from 998 mm to 980 mm (-18 mm).

2008 WR 250F - Pros & Cons

Strengths

  • Strong front braking: The disc front brake gives excellent stopping power and responds well to aftermarket braided lines.

Considerations

  • Tall seat height: The 980 mm seat height will challenge shorter riders - tiptoeing at low speeds is something to factor into your decision.
  • Modest fuel capacity: The 8-litre tank means more frequent fuel stops on longer rides, which is worth planning around on touring routes.
  • Chain final drive upkeep: Chain final drive needs regular cleaning, lubrication and tension checks to get full life out of the sprockets.

Wear Points & Servicing Notes

Cooling system servicing

The Liquid cooled, system on the WR 250F needs a coolant change roughly every two years (or per the service schedule) - skipping it lets the coolant turn acidic and corrode the aluminium water passages over time.

Valve clearance checks

DOHC valve actuation on the WR 250F means clearances should be checked at the manufacturer's specified interval - they can tighten as mileage accumulates, and a light top-end tick is usually the first sign.

Brake disc and pad wear

The disc front brake gives strong, progressive stopping power. Disc thickness and pad depth are worth checking at every tyre change, since worn pads can score the disc surface.

Suspension condition on used examples

Up front, the WR 250F runs 48mm Fully adjustable inverted forks and Fully adjustable link Monocross at the rear. On a used example, check fork seals for weeping oil and test the rear linkage for play - seals are a relatively cheap fix but useful when negotiating price.

Final drive maintenance

Final drive is by chain - expect to clean and lube it every few hundred kilometres and check tension regularly; a neglected chain wears the sprockets faster than the chain itself.

Frame & chassis check

The frame is Aluminium Bilateral Beam - worth a visual check for corrosion or impact damage around the head-stock and swingarm pivot on any used example, since frame damage is far costlier to fix than any service item.

Low-speed handling

At just 129 kg, the WR 250F is light enough to manhandle easily at a standstill - one of the practical advantages of its class.

WR 250F - Buying & Maintenance Guide

What to check before buying

When inspecting a used 2008 Yamaha WR 250F with its 249 cc enduro / off-road, start with the basics: check the service book for oil change frequency, inspect the drivetrain for wear, and look for oil seepage around the engine casings and rocker covers. This model runs chain final drive, so check chain slack and sprocket tooth profile specifically - a worn sprocket is a cheaper fix now than after it's chewed up the next chain. Now 18 years old, this enduro / off-road is as likely to show age-related wear (perished rubber, seized fasteners, degraded seals) as mileage-related wear. A cold start test is invaluable - a well-maintained WR 250F should fire up cleanly and settle to a smooth idle within a few seconds.

Oil and filter changes

Regular oil changes are the single most important maintenance task for the WR 250F's 249 cc single cylinder. Stick to the manufacturer's interval - typically every 6,000 km or once a year, whichever comes first. With a 12.5:1 compression ratio, running the octane grade specified in the manual matters more than on a lower-compression engine. Always use the correct viscosity grade as specified in the owner's manual.

Carburetor upkeep

Keep the carburetors clean and free of deposits. If the WR 250F has been stored, strip and clean the carb float bowls before attempting to start it. Pilot jets are the first to block and the last to be checked - always include them in any carb rebuild.

Valve clearance service

Check that valve clearances have been adjusted at the correct intervals on any used WR 250F. A bike with clearances out of spec doesn't always feel obviously wrong - but tight clearances accelerate valve seat wear. Ask for service documentation proving it's been done.

2008 Yamaha WR 250F - Frequently Asked Questions

What engine does the 2008 Yamaha WR 250F have?
The 2008 Yamaha WR 250F uses a Single cylinder engine with 249 cc of displacement. It is liquid cooled,.
How much does the 2008 Yamaha WR 250F weigh?
The 2008 Yamaha WR 250F weighs 129 kg. This is the manufacturer's wet figure.
What is the fuel tank capacity of the 2008 Yamaha WR 250F?
The 2008 Yamaha WR 250F has an 8-litre fuel tank. At around 5-6 litres per 100 km, that is roughly 133-160 km between stops.
Is the 2008 Yamaha WR 250F suitable for shorter riders?
The 2008 Yamaha WR 250F has a seat height of 980 mm. This is towards the tall end of the spectrum and will require most riders under 175 cm to tiptoe at stops.
What brakes does the 2008 Yamaha WR 250F have?
The 2008 Yamaha WR 250F uses single 250mm disc 2 piston caliper at the front and single 240mm disc 1 piston caliper at the rear.
What tyre sizes does the 2008 Yamaha WR 250F use?
The 2008 Yamaha WR 250F runs 80/100-21 front and 100/100-18 rear tyres. A good selection of sport, touring and all-weather rubber is available in these sizes.
What gearbox does the 2008 Yamaha WR 250F have?
The 2008 Yamaha WR 250F is fitted with a 5 Speed transmission.

Yamaha WR 250F Spec Evolution

The Yamaha WR 250F was produced across 15 model years (2002-2025). The table below highlights the key specifications that changed across the production run - useful whether you are comparing years or tracking down a specific variant.

Specification 2002 2004 2006 2008 2010 2012 2013 2015 2016 2017 2019 2021 2022 2023 2025
Wet Weight 129.0 kg / 284.4 lbs 129.0 kg / 284.4 lbs 129.0 kg / 284.4 lbs 129.0 kg / 284.4 lbs 117.9 kg / 260.0 lbs 129.0 kg / 284.4 lbs 129.0 kg / 284.4 lbs 117.0 kg / 258 lbs 117.0 kg / 258 lbs 117 kg / 258 lbs 117 kg / 258 lbs 115.2 kg / 254.0 lbs 115 kg / 253.5 lbs 115.2 kg / 254.0 lbs 113kg / 249 lbs
Dry Weight 106 kg / 233.2 lbs 106 kg / 233.2 lbs 106 kg / 233.2 lbs 106 kg / 233.2 lbs 106 kg / 233.2 lbs 106 kg / 233.2 lbs 106 kg / 233.2 lbs 59 kg / 130.1 lbs - - - - - - -
Engine Detail Four stroke, single cylinder, DOHC, 5 valve Four stroke, single cylinder, DOHC, 5 valve Four stroke, single cylinder, DOHC, 5 valve Four stroke, single cylinder, DOHC, 5 valve Four stroke, single cylinder, DOHC, 5 valve Four stroke, single cylinder, DOHC, 5 valve Four stroke, single cylinder, DOHC, 5 valve Four stroke, single cylinder, DOHC, 4 valve Four stroke, single cylinder, DOHC, 4 valve Four stroke, single cylinder, DOHC, 4 valve Titanium Four stroke, single cylinder, DOHC, 4 valve Titanium Four stroke, single cylinder, DOHC, 4 valve Titanium Four stroke, single cylinder, DOHC, 4 valve Titanium Rearward-slanted cylinders Four stroke, single cylinder, DOHC, 4 valve Titanium
Engine Type Single cylinder Single cylinder Single cylinder Single cylinder Single cylinder Single cylinder, four-stroke Single cylinder, four-stroke Single cylinder, four-stroke Single cylinder, four-stroke Single cylinder, four-stroke Single cylinder, four-stroke Single cylinder, four-stroke Single cylinder, four-stroke Single cylinder, four-stroke -
Seat Height 998 mm / 39.3 in 998 mm / 39.3 in 998 mm / 39.3 in. 980 mm / 38.6 in 980 mm / 38.6 in 980 mm / 38.6 in. 980 mm / 38.6 in 965 mm / 38.0 in 965 mm / 38.0 in 965 mm / 38.0 in 965 mm / 38.0 in 965 mm / 38.0 in 955 mm / 37.5 in 955 mm / 37.6 in. 955 mm / 37.6 in
Fuel Capacity 8 Liters / 2.1 US gal 8 Liters / 2.1 US gal 8 Liters / 2.1 gal 8 Liters / 2.1 gal 7.94 litres / 2.10 gallons 8 Liters / 2.1 gal 8 Liters / 2.1 gal 7.5 Litres / 2.0 gal 7.5 Litres / 2.0 gal 7.5 Litres / 2.0 gal 7.50 litres / 1.98 US gallons 8.33 litres / 2.20 US gallons 7.9 Litres / 2.1 gal 8.14 litres / 2.15 US gallons 7.5 Litres / 2.0 gal
Oil Capacity (Quarts) - - - - - - - 0.08 quarts 0.07 quarts 0.07 quarts 1.16 US quarts 1.16 US quarts 1.16 US quarts 1.16 US quarts -
Oil Capacity (l) - - - - - - - 1.20 litres 1.10 litres 1.10 litres 1.10 litres 1.10 litres 1.10 litres 1.10 litres -

Key Specifications

Engine

Single cylinder

Power

Not recorded

Torque

Not recorded

Top Speed

Not recorded

Weight

129.0 kg / 284.4 lbs

Fuel Capacity

8 Liters / 2.1 gal

Advertisement

Full 2008 Yamaha WR 250F Specifications

Year 2007 - 08
Make Model Yamaha WR 250F
Ground Clearance (in.) 14.4 inches
Ground Clearance (mm) 366 mm
Seat Height 980 mm / 38.6 in
Wheelbase 1475 mm / 58.1 in
Ground Clearance 335 mm / 13.2 in
Height 1275 mm / 50.2 in
Length 2315 mm / 91.1 in
Width 826 mm / 32.5 in
Dry Weight 106 kg / 233.2 lbs
Fuel Capacity 8 Liters / 2.1 gal
Wet Weight 129.0 kg / 284.4 lbs
Engine Type Single cylinder
Fuel Control DOHC
Stroke 4
Displacement (cc) 250.00 cc
Bore x Stroke (mm) 77.0 x 53.6 mm
Bore x Stroke (in,) 3.0 x 2.1 inches
Displacement (ci) 15.26 cubic inches
Displacement 249 cc / 15.2 cu-in
Engine Detail Four stroke, single cylinder, DOHC, 5 valve
Fuel System Carburettor
Bore x Stroke 77 x 53.6 mm
Compression Ratio 12.5:1
Cooling System Liquid cooled,
Fuel Induction Keihin FCR-MX37 flat-slide w/throttle position sensor)
Ignition Digital CDI
Lubrication Dry sump
Starter Electric / Kick
Clutch Wet, multiple discs, cable operated
Final Drive #520 Chain
Gearbox 5-speed
Transmission / Drive 5 Speed
Frame Type Aluminium Bilateral Beam
Suspension - Front 48mm Fully adjustable inverted forks
Suspension - Rear Fully adjustable link Monocross
Rake 27.0°
Trail 115 mm / 4.5 in
Wheel Travel - Front 300 mm / 11.8 in
Wheel Travel - Rear 305 mm / 12.0 in
Brakes - Front Diameter (in.) 9.8 inches
Brakes - Front Diameter (mm) 250 mm
Brakes - Rear Diameter (in.) 9.6 inches
Brakes - Rear Diameter (mm) 245 mm
Brakes - Front Single 250mm disc 2 piston caliper
Brakes - Rear Single 240mm disc 1 piston caliper
Tyres - Front 80/100-21
Tyres - Rear 100/100-18

Specifications are compiled from manufacturer documentation and cross-referenced technical sources, and corrected on an ongoing basis. Spot an error? Let us know.

Advertisement