2018 Husqvarna FS 450 Specifications

Super motard

Advertisement
No images available
Tap to enlarge

2018 Husqvarna FS 450 Overview

The 2018 Husqvarna FS 450 is a super motard motorcycle built around 449.30 cc of displacement. Under the tank sits a Single cylinder, four-stroke engine running Single Overhead Cams (SOHC) valve actuation. The bore and stroke measures 95 x 63.4 mm. From a practical standpoint, the 2018 FS 450 tips the scales at 110 kg, carries a 9.50-litre fuel tank, offers a seat height of 927 mm and spans a 1,475 mm wheelbase. Scroll down for the complete 2018 Husqvarna FS 450 spec sheet covering every technical detail from suspension travel to tyre sizes.

2018 FS 450 - Pros & Cons

Strengths

  • Factory engineering: The 2018 Husqvarna FS 450 represents Husqvarna's engineering at the time, with a specification built around real-world usability.

Considerations

  • Carburetor fuelling: Carbureted engines need occasional jetting attention and can be reluctant in cold weather or at altitude compared to modern fuel-injected alternatives.
  • Tall seat height: The 927 mm seat height will challenge shorter riders - tiptoeing at low speeds is something to factor into your decision.

Owner Experiences & Common Issues

Carburetor maintenance

Carburetors on the 2018 Husqvarna FS 450 benefit from a clean and re-jet if the bike has been stored, run on stale fuel, or modified with an aftermarket exhaust. Owners frequently mention that fresh jets and float needle clips transforms throttle response from flat to crisp.

Valve clearance checks

Single Overhead Cams (SOHC) engines should have valve clearances checked at the manufacturer's specified interval. Owners report that clearances can tighten over time on higher-mileage bikes, leading to slight ticking from the top end. Catching it early keeps the job simple and avoids more costly remediation.

FS 450 - Buying & Maintenance Guide

What to check before buying

When inspecting a used 2018 Husqvarna FS 450, start with the basics: check the service book for oil change frequency, inspect the chain and sprockets for wear, and look for oil seepage around the engine casings and rocker covers. A cold start test is invaluable - a well-maintained FS 450 should fire up cleanly and settle to a smooth idle within a few seconds.

Oil and filter changes

Regular oil changes are the single most important maintenance task on any FS 450. Stick to the manufacturer's interval - typically every 6,000 km or once a year, whichever comes first. Always use the correct viscosity grade as specified in the owner's manual.

Carburetor upkeep

Keep the carburetors clean and free of deposits. If the FS 450 has been stored, strip and clean the carb float bowls before attempting to start it. Pilot jets are the first to block and the last to be checked - always include them in any carb rebuild.

Valve clearance service

Check that valve clearances have been adjusted at the correct intervals on any used FS 450. This is a job many owners skip because the bike does not immediately feel wrong - but tight clearances accelerate valve seat wear. Ask for proof it has been done.

2018 Husqvarna FS 450 - Frequently Asked Questions

What engine does the 2018 Husqvarna FS 450 have?
The 2018 Husqvarna FS 450 uses a Single cylinder, four-stroke engine with 449.30 cc of displacement.
How much does the 2018 Husqvarna FS 450 weigh?
The 2018 Husqvarna FS 450 weighs 110 kg. This is the manufacturer's dry figure.
What is the fuel tank capacity of the 2018 Husqvarna FS 450?
The 2018 Husqvarna FS 450 has a 9.50-litre fuel tank.
Is the 2018 Husqvarna FS 450 suitable for shorter riders?
The 2018 Husqvarna FS 450 has a seat height of 927 mm. This is towards the tall end of the spectrum and will require most riders under 175 cm to tiptoe at stops.
What brakes does the 2018 Husqvarna FS 450 have?
The 2018 Husqvarna FS 450 uses Single disc. Brembo four-piston radial fixed calliper at the front and Single disc. Brembo single-piston floating calliper at the rear.
What tyre sizes does the 2018 Husqvarna FS 450 use?
The 2018 Husqvarna FS 450 runs 90/90-17 front and 140/90-17 rear tyres. A good selection of sport, touring and all-weather rubber is available in these sizes.
What fuel system does the 2018 Husqvarna FS 450 use?
The 2018 Husqvarna FS 450 uses Carburettor, providing precise fuelling across the rev range and reliable cold-start behaviour.

Husqvarna FS 450 Spec Evolution

The Husqvarna FS 450 was produced across 8 model years (2016-2023). The table below highlights the key specifications that changed across the production run - useful whether you are comparing years or tracking down a specific variant.

Specification 2016 2017 2018 2019 2020 2021 2022 2023
Dry Weight 110 kg / 242.5 lbs 110 kg / 242.5 lbs 110 kg / 242.5 lbs 102.9 kg / 226.9 lbs 102.8 kg / 226.6 lbs 102.8 kg / 226.6 lbs 103 kg / 227.1 lbs 107.6 kg / 237.2 lbs
Seat Height 927 mm / 36.5 in. 927 mm / 36.5 in. 927 mm / 36.5 in. 890 mm / 35.0 in. 890 mm / 35.0 in. 890 mm / 35.0 in. 890 mm / 35.0 in. 898 mm / 35.4 in.
Fuel Capacity 9.50 litres / 2.51 gallons 9.50 litres / 2.51 gallons 9.50 litres / 2.51 gallons 9.50 litres / 2.51 US gallons 7.00 litres / 1.85 US gallons 7.00 litres / 1.85 US gallons 7.00 litres / 1.85 US gallons 7.20 litres / 1.90 US gallons
Ground Clearance (mm) 290 mm 290 mm 290 mm 290 mm 290 mm 290 mm 290 mm 281 mm
Ground Clearance (in.) 11.4 inches 11.4 inches 11.4 inches 11.4 inches 11.4 inches 11.4 inches 11.4 inches 11.1 inches
Displacement (ci) 27.42 cubic inches 27.42 cubic inches 27.42 cubic inches 27.45 cubic inches 27.45 cubic inches 27.45 cubic inches 27.45 cubic inches 27.45 cubic inches
Displacement (cc) 449.30 cc 449.30 cc 449.30 cc 449.9 cc 449.9 cc 449.9 cc 449.9 cc 449.9 cc
Comments - - - - - - 2 engine maps. Traction control, 2 engine maps.

Key Specifications

Engine

Single cylinder, four-stroke

Power

N/A

Torque

N/A

Top Speed

N/A

Weight

110 kg / 242.5 lbs

Fuel Capacity

9.50 litres / 2.51 gallons

Advertisement

Full 2018 Husqvarna FS 450 Specifications

Colours Blue/yellow/white
Warranty 2 Years
Power-to-Weight Ratio 0.5727 HP/kg
Bore x Stroke (in,) 3.7 x 2.5 inches
Bore x Stroke (mm) 95.0 x 63.4 mm
Displacement (cc) 449.30 cc
Displacement (ci) 27.42 cubic inches
Engine Type Single cylinder, four-stroke
Fuel Control Single Overhead Cams (SOHC)
Fuel System Carburettor
Ignition Keihin EMS
Starter Electric
Advertisement

Compare Husqvarna FS 450

See how the 2018 Husqvarna FS 450 stacks up against similar motorcycles.

Build your own comparison →