2008 Vespa S 50 Specifications

Name: 2008 Vespa S 50
Brand: Vespa

Scooter • Specs last verified 13 July 2026

No images available

Tap to enlarge

2008 Vespa S 50 Overview

For 2008, Vespa offers the S 50 as a scooter motorcycle with 50 cc on tap. The 2008 Vespa S 50 is built around a Single cylinder engine. In everyday use, the 2008 S 50 tips the scales at 96 kg and carries an 8.60-litre fuel tank. Every technical detail, from suspension travel to tyre sizes, is covered in the full 2008 Vespa S 50 spec sheet below.

2008 Vespa S 50 compared with other bikes in the Scooter category

Measured against other bikes in the Scooter category in our database (up to 1110 models, one entry per model), the 2008 Vespa S 50 comes out as follows.

With 50 cc, the S 50 has the joint 216th smallest engine displacement of 1110 bikes in the Scooter category, 74% below the category average of 194 cc.
Narrowing the field to the 570 models within five model years of it, the engine displacement of 50 cc is smaller than that of 426 of the other 569.

2008 S 50 - Pros & Cons

Strengths

Fuel injection: No choke, no jetting, no altitude compensation to think about - fuel injection just works across a wider range of conditions than carburetion.
Strong front braking: The single disc front brake bites hard and stays consistent - a solid foundation whether it's stock or upgraded with braided lines.

Considerations

Drum rear brake: A drum rear brake is simple and durable, but expect less bite and more fade under hard, repeated use than a disc setup.
Modest fuel capacity: An 8.60-litre tank keeps things light but means budgeting for more frequent fuel stops on any longer ride.

Wear Points & Servicing Notes

Fuelling & injector care

Fuelling on the S 50 comes from fuel injection. Cold starts and throttle response stay consistent across altitude and temperature, the main practical edge over a carbureted equivalent.

Brake disc and pad wear

Single disc up front provides the primary stopping power; inspect disc thickness and pad wear at each tyre change to catch scoring before it becomes a rotor replacement.

Low-speed handling

The S 50's 96 kg kerb weight makes low-speed control noticeably less effort than on a heavier machine.

S 50 - Buying & Maintenance Guide

What to check before buying

A pre-purchase check on the 2008 Vespa S 50 with its 50 cc scooter should cover the same ground every time: service history, drivetrain condition, and any oil seepage around the casings. Now 18 years old, this scooter is as likely to show age-related wear (perished rubber, seized fasteners, degraded seals) as mileage-related wear. Start it from cold if you can - a well-kept S 50 settles to a smooth idle within seconds.

Oil and filter changes

Oil changes are the cheapest insurance you can buy for the S 50's 50 cc single cylinder - keep to the manufacturer's interval rather than stretching it. Use the viscosity grade the manual specifies, not whatever's on sale.

Fuel system care

Injector systems like the S 50's hold up well with basic care - decent fuel, an occasional cleaner additive, and draining old fuel before any layup longer than three months.

2008 Vespa S 50 - Frequently Asked Questions

What engine does the 2008 Vespa S 50 have?

The 2008 Vespa S 50 uses a Single cylinder engine with 50 cc of displacement.

How much does the 2008 Vespa S 50 weigh?

The 2008 Vespa S 50 weighs 96 kg. This is the manufacturer's dry figure.

What is the fuel tank capacity of the 2008 Vespa S 50?

The 2008 Vespa S 50 has an 8.60-litre fuel tank. At around 5-6 litres per 100 km, that is roughly 143-171 km between stops.

What brakes does the 2008 Vespa S 50 have?

The 2008 Vespa S 50 uses single disc at the front and Expanding brake at the rear.

What tyre sizes does the 2008 Vespa S 50 use?

The 2008 Vespa S 50 runs 110/70-11 front and 120/70-10 rear tyres. A good selection of sport, touring and all-weather rubber is available in these sizes.

What fuel system does the 2008 Vespa S 50 use?

The 2008 Vespa S 50 uses Injection, providing precise fuelling across the rev range and reliable cold-start behaviour.

Vespa S 50 Spec Evolution

The Vespa S 50 was produced across 3 model years (2008-2010). The table below highlights the key specifications that changed across the production run - useful whether you are comparing years or tracking down a specific variant.

Specification	2008	2009	2010
Engine Type	Single cylinder	Single cylinder	Single cylinder, two-stroke
Brakes - Front Diameter (in.)	8.7 inches	7.9 inches	7.9 inches
Brakes - Front Diameter (mm)	220 mm	200 mm	200 mm
Stroke	4	2	-
Fuel System	Injection	-	Carburettor
Colours	Ottico White, Dragon Red, Black	Rosso Dragon, Nero Lucido, Montebianco	Nero Lucido, Montebianco, Taormina
Exhaust	-	Euro II	Euro I2

Key Specifications

Engine

Single cylinder

Power

Not recorded

Torque

Not recorded

Top Speed

Not recorded

Weight

96 kg / 211.6 lbs

Fuel Capacity

8.60 litres / 2.27 gallons

Full 2008 Vespa S 50 Specifications

Colours Ottico White, Dragon Red, Black

Dry Weight 96 kg / 211.6 lbs

Fuel Capacity 8.60 litres / 2.27 gallons

Displacement (cc) 50.00 cc

Displacement (ci) 3.05 cubic inches

Engine Type Single cylinder

Stroke 4

Fuel System Injection

Starter Electric & kick

Gearbox Automatic

Brakes - Front Diameter (in.) 8.7 inches

Brakes - Front Diameter (mm) 220 mm

Brakes - Rear Diameter (in.) 4.3 inches

Brakes - Rear Diameter (mm) 110 mm

Brakes - Front Single disc

Brakes - Rear Expanding brake (drum brake)

Tyres - Front 110/70-11

Tyres - Rear 120/70-10

Specifications are compiled from manufacturer documentation and cross-referenced technical sources, and corrected on an ongoing basis. Spot an error? Let us know.