![]()
No images available
Tap to enlarge
![]()
2014 KTM Freeride 250R Overview
For 2014, KTM offers the Freeride 250R as an enduro / off-road motorcycle with 249 cc on tap. The 2014 KTM Freeride 250R is built around a Single cylinder, two-stroke engine, a compression ratio of 12.3:1. Out on the road, the Freeride 250R delivers NA of peak power and NA of torque. Flat out, it's quoted at 45.1 km/h. In everyday use, the 2014 Freeride 250R tips the scales at 112 kg, carries a 7-litre fuel tank, offers a seat height of 915 mm and spans a 1418 mm wheelbase. That's roughly 86.8 kg lighter than the average enduro / off-road motorcycle in our database. Every technical detail, from suspension travel to tyre sizes, is covered in the full 2014 KTM Freeride 250R spec sheet below.
2014 Freeride 250R - Pros & Cons
Strengths
-
⚡
Strong power output: Peak output on the Freeride 250R is NA and NA of torque - strong numbers for what it is.
Considerations
-
🔧
Carburetor fuelling: Carburetion is more hands-on than fuel injection - plan on periodic jetting and cleaning as part of routine ownership.
-
📏
Tall seat height: A 915 mm seat puts flat-footing out of reach for a lot of riders - sit on it in person before committing.
-
⛽
Modest fuel capacity: A 7-litre tank keeps things light but means budgeting for more frequent fuel stops on any longer ride.
-
⚙️
Chain final drive upkeep: A chain drivetrain is the most common setup in its class, but it's also the one that demands the most regular hands-on maintenance.
Wear Points & Servicing Notes
Cooling system servicing
With Liquid Cooled, thermal management is largely automatic, but the coolant has a service life of its own - replace it on the manufacturer's interval to protect the water passages and thermostat.
Carburetor maintenance
Being carbureted, the Freeride 250R is more sensitive to stale fuel and altitude changes than a fuel-injected bike - a carb clean and rejet restores crisp throttle response after any extended lay-up.
Brake disc and pad wear
Single 260mm disc 2 piston caliper up front provides the primary stopping power; inspect disc thickness and pad wear at each tyre change to catch scoring before it becomes a rotor replacement.
Suspension condition on used examples
Suspension duties are handled by WP Suspension4357 MXMA up front and WP-PDS shock absorber, at the rear. Weeping fork seals aren't a dealbreaker on a used bike, but they're a fair basis for negotiating price.
Final drive maintenance
Chain final drive on the Freeride 250R means routine lubing and tension checks are part of ownership - skip them and sprocket wear accelerates noticeably.
Frame & chassis check
The Perimeter steel-aluminium composite frame chassis holds up well with normal use; on a used bike it's still worth checking the head-stock and swingarm pivot area for impact damage or corrosion.
Low-speed handling
The Freeride 250R's 112 kg kerb weight makes low-speed control noticeably less effort than on a heavier machine.
Freeride 250R - Buying & Maintenance Guide
What to check before buying
A pre-purchase check on the 2014 KTM Freeride 250R should cover the same ground every time: service history, chain and sprocket condition, and any oil seepage around the casings. Start it from cold if you can - a well-kept Freeride 250R settles to a smooth idle within seconds.
Oil and filter changes
Oil changes are the cheapest insurance you can buy for a Freeride 250R's engine - keep to the manufacturer's interval rather than stretching it. Use the viscosity grade the manual specifies, not whatever's on sale.
Carburetor upkeep
A Freeride 250R that's sat unused is almost always a carb-cleaning job before it runs right again - float bowls and pilot jets first, since they clog before anything else.
2014 KTM Freeride 250R - Frequently Asked Questions
What engine does the 2014 KTM Freeride 250R have?
The 2014 KTM Freeride 250R uses a Single cylinder, two-stroke engine with 249 cc of displacement. It is liquid cooled.
What is the top speed of the 2014 KTM Freeride 250R?
The 2014 KTM Freeride 250R has a factory-quoted top speed of 45.1 km/h. Real-world speeds vary depending on rider weight, conditions and state of tune.
How much does the 2014 KTM Freeride 250R weigh?
The 2014 KTM Freeride 250R weighs 112 kg. This is the manufacturer's wet figure.
How much power does the 2014 KTM Freeride 250R make?
The 2014 KTM Freeride 250R produces NA of power and NA of torque. These are peak figures.
What is the fuel tank capacity of the 2014 KTM Freeride 250R?
The 2014 KTM Freeride 250R has a 7-litre fuel tank. At around 5-6 litres per 100 km, that is roughly 116-140 km between stops.
Is the 2014 KTM Freeride 250R suitable for shorter riders?
The 2014 KTM Freeride 250R has a seat height of 915 mm. This is towards the tall end of the spectrum and will require most riders under 175 cm to tiptoe at stops.
What brakes does the 2014 KTM Freeride 250R have?
The 2014 KTM Freeride 250R uses Single 260mm disc 2 piston caliper at the front and Single 210mm disc 1 piston caliper at the rear.
What tyre sizes does the 2014 KTM Freeride 250R use?
The 2014 KTM Freeride 250R runs 80/100-21 front and 110/90-19 rear tyres. A good selection of sport, touring and all-weather rubber is available in these sizes.
What gearbox does the 2014 KTM Freeride 250R have?
The 2014 KTM Freeride 250R is fitted with a 6 Speed, claw shifted transmission.
KTM Freeride 250R Spec Evolution
The KTM Freeride 250R was produced across 3 model years (2015-2018). The table below highlights the key specifications that changed across the production run - useful whether you are comparing years or tracking down a specific variant.
| Specification |
2015 |
2017 |
2018 |
| Dry Weight |
92.5 kg / 204 lbs |
92.5 kg / 203.9 lbs |
92.5 kg / 204 lbs |
| Seat Height |
915 mm / 36.0 in |
915 mm / 36.0 in |
915 mm / 36.0 in |
| Fuel Capacity |
7.00 litres / 1.85 gallons |
7.0 Litres / 1.85 US gal |
7.0 Litres / 1.85 US gal |
| Frame Type |
Perimeter steel-aluminium composite frame |
Perimeter steel-aluminium composite frame. |
Perimeter steel-aluminium composite frame |
| Wheelbase |
1418 mm / 55.8 in |
1,418 mm / 55.8 in. |
1418 mm / 55.8 in |
| Brakes - Front |
Single 260mm disc 2 piston caliper |
Single 260mm disc 2 piston caliper |
Single 260mm disc 2 piston caliper |
| Brakes - Rear |
Single disc. Two-piston calipers. Radially mounted. |
Single 210mm disc 1 piston caliper |
Single 210mm disc 1 piston caliper |
| Suspension - Front |
WP ?Suspension4357 MXMA |
WP Suspension4357 MXMA |
WP Suspension4357 MXMA |
Key Specifications
Engine
Single cylinder, two-stroke
Top Speed
45.1 km/h / 28.0 mph
Weight
112.0 kg / 246.9 lbs
Fuel Capacity
7.0 Litres / 1.85 US gal
Advertisement
Full 2014 KTM Freeride 250R Specifications
Comments
German brand.
Year
2014 - 15
Colours
Orange/white/gray
Make Model
KTM Freeride 250R
Ground Clearance (mm)
380 mm
Ground Clearance (in.)
15.0 inches
Seat Height
915 mm / 36.0 in
Wheelbase
1418 mm / 55.8 in
Ground Clearance
325 mm / 12.7 in
Height
1,120 mm / 44.1 in.
Length
2,120 mm / 83.5 in.
Width
840 mm / 33.1 in.
Dry Weight
92.5 kg / 204 lbs
Fuel Capacity
7.0 Litres / 1.85 US gal
Wet Weight
112.0 kg / 246.9 lbs
Engine Type
Single cylinder, two-stroke
Displacement
249 cc / 15.2 cu-in
Engine Detail
Two stroke, single cylinder
Fuel System
Carburettor
Bore x Stroke
66.4 X 72 mm
Compression Ratio
12.3:1
Cooling System
Liquid Cooled
Emissions
Euro 2
Engine Lubrication
Mixture oil lubrication
Exhaust
Stainless steel exhaust
Fuel Induction
Carburettor
Ignition
Contactless, controlled, fully electronic ignition system with digital ignition timing adjustment, type Kokusan
Starter
Electric
Clutch
Wet multi-disc clutch, Brembo hydraulics
Final Drive
Chain 5/8 x 1/4" X Ring
Gearbox
6-speed
Primary Drive
5/8 x 1/4 X Ring
Primary Drive Ratios
26:72
Transmission / Drive
6 Speed, claw shifted
Frame Type
Perimeter steel-aluminium composite frame
Suspension - Front
WP Suspension4357 MXMA
Suspension - Rear
WP-PDS shock absorber,
Rake
23.0°
Steering Head Angle
67°
Wheel Travel - Front
250 mm / 9.8 in
Wheel Travel - Rear
280 mm / 11.0 in
Instrumentation
Digital cockpit
Brakes - Front Diameter (in.)
10.2 inches
Brakes - Front Diameter (mm)
260 mm
Brakes - Rear Diameter (in.)
8.3 inches
Brakes - Rear Diameter (mm)
210 mm
Brakes - Front
Single 260mm disc 2 piston caliper
Brakes - Rear
Single 210mm disc 1 piston caliper
Tyres - Front
80/100-21
Tyres - Rear
110/90-19
Specifications are compiled from manufacturer documentation and cross-referenced
technical sources, and corrected on an ongoing basis.
Spot an error? Let us know.
Advertisement